Sargent and Greenleaf 6120 Instructions d'exploitation télécharger pdf (Page 11)

If all of the preceding remedies have been exhausted

and the lock still does not open, contact a qualified safe

technician in your area for professional service.

to open the lock

Press the code digits or letters in order, followed by #. The lock

bolt will retract for six seconds, allowing you time to operate the

safe handle and open the door. Do not put any pressure on the

safe handle until after the code has been entered. The Model

6120 will lock automatically when the safe door is closed and

the handle is turned to the locked position.

Note: The Master Code Holder is responsible for maintaining

the number of active users programmed into each lock.

in cAse of trouble

If your lock should fail to open when a valid code is entered,

check for the following:

1. The boltwork of a safe can, under certain conditions, place

pressure on the side of the lock’s bolt. This is often caused

by something inside the safe pressing against the door or by

something caught between the safe door and its frame. When

this occurs, the lock will not operate properly. To relieve side

pressure on the lock bolt, move the safe’s handle to the fully

locked position, then re-enter a working code. The lock should

open after the pressure is removed.

2. If the lock “chirps” when keys are pressed, but it will not

open, the batteries may be drained to the point that they will

not operate the lock’s motor. Follow the battery replacement

procedure in this manual.

3. If the lock makes no sound when any of the keys are pressed,

dead batteries are likely to be the cause. Follow the battery

replacement procedure in this manual.

4. This item applies to the two-battery keypad only:

If the lock makes no sound when any of the keys are pressed,

but the batteries have been checked and found to be good,

a loose keypad connector may be the cause. Pull the keypad

away from the base as described in the battery changing

procedure. Check to make sure the wire connector is firmly

seated into its receptacle on the keypad circuit board. The

connector is designed so that it will only slide into the

receptacle when aligned correctly.

Operating Instructions

Model 6120 —Motorized Electronic Combination Lock

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Pas de commentaire

Sargent and Greenleaf 6120 Instructions d'exploitation Page 11